SkyDby
Open the three steps on the left, then Generate
Per-rack OOBTop of the rack · Auto · no extra port
Estimates only.The power figures in this tab are estimates, based on typical power draw, not measurements. They will be refined in the near future. To use your own values, edit Power assumptions at the bottom of the Power & BOM view.
Lay out the hall
Four steps place the racks, cable them and size the optics. Each starts from a working default.
Floor plan — drag racks on the room grid (drop on a rack to swap, double-click to rename)
A trunk line joins two racks that carry cables between them; its width grows with the number of cables. Blue = fiber links, bundled into MPO trunks of the selected size (hover for fibers and trunk count). Orange = direct runs only (DAC, AOC, Cat6), which do not go through trunks. Same-rack links are not drawn. Tick a link category to draw its links here and narrow the routes table (Fibers) to it; none is ticked at first.
ComputeNetworkHybridEmptyCross-row tray
Rows run left → right, positions top → bottom (as on a hall drawing). Click an aisle width to change it. Selected rack: distances to the others are shown on their tiles.
Cable lengths and routes
Rack pairs — every link between a rack and the racks it talks to
Optics — the modules to buy, and the technology of each link
Rack table — positions (row / position), reserved switch U per compute rack and power feed per rack
Rack-to-rack distance matrix
Rack elevation (drag devices to reposition)
- Drag
- orbit
- Right-drag
- pan
- Pinch
- zoom
- Double-click
- centre
- Click
- a rack or a bundle
- L
- Lift the network: a fabric’s switches in tiers over the hall. Hover one for its links, click it to see it in its rack.